Search Results for "esp32"

An Arduino IDE compatible graphics and fonts library for 32-bit processors. The library is targeted at 32-bit processors, it has been performance-optimized for STM32, ESP8266 and ESP32 types. The library can be loaded using the Arduino IDE's Library Manager. Direct Memory Access (DMA) can be used with the ESP32, RP2040, and STM32 processors to improve rendering performance. "Four wire" SPI and 8 bit parallel interfaces are supported. Due to the lack of GPIO pins, the 8-bit parallel interface is NOT supported on the ESP8266. 8 bit parallel interface TFTs (e.g. ...

Arduino library for parsing and decoding MOD, WAV, MP3, FLAC, MIDI, AAC, and RTTL files and playing them on an I2S DAC or even using a software-simulated delta-sigma DAC with dynamic 32x-128x oversampling. ESP8266 is fully supported and most mature, but ESP32 is also mostly there with built-in DAC as well as external ones. For real-time, autonomous speech synthesis, check out ESP8266SAM, a library that uses this one and a port of an ancient format-based synthesis program to allow your ESP8266 to talk with low memory and no network required. All this code is released under the GPL, and all of it is to be used at your own risk. ...

PICSimLab is a realtime emulator of development boards with MPLABX/avr-gdb debugger integration. PICSimLab supports microcontrollers from picsim, simavr, uCsim, qemu-stm32, qemu-esp32, and gpsim. PICSimLab has integration with MPLABX/Arduino IDE for programming the microcontroller's boards. As the purpose of PICSimLab is to emulate real hardware it does not have any source code editing support. For code editing and debugging the same tools used for a real board should be used with PICSimLab, such as MPLABX, Arduino IDE, or VSCode with PlatformIO. ...

...Enjoy the "one-key" build, "one-key" upload, and work to link various other Arduino libraries with Apple HomeKit! This library is built with ESP8266 Arduino Core 2.6.3. Lower versions may compile with errors. For ESP32, see Arduino-HomeKit-ESP32. The HomeKit running on ESP32 has a GREAT PERFORMANCE which is 10x faster than ESP8266. You should set the ESP8266 CPU to run at 160MHz (at least during the pairing process), to avoid the tcp-socket disconnection from the iOS device caused by a timeout.